[ < ] [ > ]   [ << ] [ Up ] [ >> ]         [Top] [Contents] [Index] [ ? ]

2.3 The Uniform Naming Scheme

Automake variables generally follow a uniform naming scheme that makes it easy to decide how programs (and other derived objects) are built, and how they are installed. This scheme also supports configure time determination of what should be built.

At make time, certain variables are used to determine which objects are to be built. The variable names are made of several pieces which are concatenated together.

The piece which tells automake what is being built is commonly called the primary. For instance, the primary PROGRAMS holds a list of programs which are to be compiled and linked.

A different set of names is used to decide where the built objects should be installed. These names are prefixes to the primary which indicate which standard directory should be used as the installation directory. The standard directory names are given in the GNU standards (see section `Directory Variables' in The GNU Coding Standards). Automake extends this list with pkglibdir, pkgincludedir, and pkgdatadir; these are the same as the non-`pkg' versions, but with `@PACKAGE@' appended. For instance, pkglibdir is defined as $(libdir)/@PACKAGE@.

For each primary, there is one additional variable named by prepending `EXTRA_' to the primary name. This variable is used to list objects which may or may not be built, depending on what configure decides. This variable is required because Automake must statically know the entire list of objects that may be built in order to generate a `Makefile.in' that will work in all cases.

For instance, cpio decides at configure time which programs are built. Some of the programs are installed in bindir, and some are installed in sbindir:

 
EXTRA_PROGRAMS = mt rmt
bin_PROGRAMS = cpio pax
sbin_PROGRAMS = @MORE_PROGRAMS@

Defining a primary without a prefix as a variable, e.g., PROGRAMS, is an error.

Note that the common `dir' suffix is left off when constructing the variable names; thus one writes `bin_PROGRAMS' and not `bindir_PROGRAMS'.

Not every sort of object can be installed in every directory. Automake will flag those attempts it finds in error. Automake will also diagnose obvious misspellings in directory names.

Sometimes the standard directories--even as augmented by Automake--- are not enough. In particular it is sometimes useful, for clarity, to install objects in a subdirectory of some predefined directory. To this end, Automake allows you to extend the list of possible installation directories. A given prefix (e.g. `zar') is valid if a variable of the same name with `dir' appended is defined (e.g. zardir).

For instance, until HTML support is part of Automake, you could use this to install raw HTML documentation:

 
htmldir = $(prefix)/html
html_DATA = automake.html

The special prefix `noinst' indicates that the objects in question should be built but not installed at all. This is usually used for objects required to build the rest of your package, for instance static libraries (see section 9.2 Building a library), or helper scripts.

The special prefix `check' indicates that the objects in question should not be built until the make check command is run. Those objects are not installed either.

The current primary names are `PROGRAMS', `LIBRARIES', `LISP', `PYTHON', `JAVA', `SCRIPTS', `DATA', `HEADERS', `MANS', and `TEXINFOS'.

Some primaries also allow additional prefixes which control other aspects of automake's behavior. The currently defined prefixes are `dist_', `nodist_', and `nobase_'. These prefixes are explained later (see section 9.4 Program and Library Variables).


[ < ] [ > ]   [ << ] [ Up ] [ >> ]         [Top] [Contents] [Index] [ ? ]

This document was generated by Jeff Bailey on December, 24 2002 using texi2html