NAME Device::Solenodrive - Interface to the solenodrive hardware VERSION version 0.1 SYNOPSIS my $solenodrive = Device::Solenodrive->new(device => '/dev/ttyUSB0'); DESCRIPTION Host software to interface to solenodrive hardware. METHODS "new(%parameters)" This constructor returns a new Device::Solenodrive object. Supported parameters are listed below device The target device to connect to. This can be either a serial port object (e.g. /dev/ttyUSB0) or a TCP socket (e.g. 192.168.1.52:10001). baudrate Optional parameter when using a serial port for connecting to the bootloader. Default value is 57600 bps. verbose Controls the verbosity of the module. Defaults to 0. Increasing numbers make the module more chatty. 5 is the highest level and probably provides too much information. 3 is a good level to get started. "connect_target()" Opens the connection to the device that provides the RS485 interface, should be called before trying to send commands "set(ID, channel)" Sets the channel "channel" of the Solenodrive with ID "ID" active. "enumerate()" Enumerate the devices on the bus, reports the addresses of the devices together with their firmware version. The returned object is a hash containing the address/firmware version pairs. Only supported from Solenodrive firmware v1.1 and upwards. "disconnect_target()" Closes the connection to the RS485 bus. "list_devices()" List the devices that were discovered after enumeration. "BUILD" An internal function used by Moose to run code after the constructor. Need to document because otherwise Test::Pod::Coverage test fails "O_NDELAY" Detected by Pod::Coverage from the sysopen function. Stub documenation to ensure the test does not fail when the module is deployed. "O_NOCTTY" Detected by Pod::Coverage from the sysopen function. Stub documenation to ensure the test does not fail when the module is deployed. "O_RDWR" Detected by Pod::Coverage from the sysopen function. Stub documenation to ensure the test does not fail when the module is deployed. AUTHOR Lieven Hollevoet COPYRIGHT AND LICENSE This software is copyright (c) 2013 by Lieven Hollevoet. This is free software; you can redistribute it and/or modify it under the same terms as the Perl 5 programming language system itself.